Solar Air Conditioning Refrigeration Process

Aug 11, 2025 Leave a message

When sunlight strikes the heat-absorbing plate inside the vacuum tube, the working fluid inside the heat pipe boils and vaporizes. The vapor continuously rushes to the condenser at the top, where it condenses into liquid. The condensed working fluid then flows along the tube wall back to the evaporator section, completing the cycle. This type of heat pipe, which absorbs heat and vaporizes at one end and condenses and releases heat at the other, achieving heat transfer through internal phase change, is commonly called a gravity heat pipe. Heat pipes lack a heat-absorbing core. The condensed liquid flows back from the condenser section to the evaporator section by gravity, automatically circulating without external power. This is the heat collection process of a heat pipe vacuum tube. Because heat pipes rely on gravity to circulate the working fluid, the evaporator section must be placed below the condenser section during operation. If the evaporator section is placed above the condenser section, gravity will hinder the condensate's return flow. Without power to return the condensate to the evaporator section, the heat pipe will not function. Therefore, heat pipes are also called one-way heat transfer diodes. This characteristic of heat pipes is ideally suited for solar thermal collectors. They transfer absorbed solar heat to a water tank, heating the water, with irreversible heat transfer. In other words, they absorb heat during the day but release it at night. This significantly reduces heat loss and improves the collector's thermal insulation performance.

Because heat pipes primarily rely on the absorption and release of latent heat during phase changes of the working fluid and the flow of steam to transfer heat, and since most working fluids have a high latent heat of vaporization, they can transfer significant amounts of heat without requiring a large evaporation volume. When the steam is saturated, the temperature difference during its flow and phase change is minimal. The relatively thin pipe wall results in a very small surface temperature gradient. When the heat flux is very low, a highly isothermal surface is achieved, improving thermal conductivity. The installation angle of the heat pipe has a certain impact on heat transfer performance.